[Elecraft] SteppIR controller with K3S+P3

[Dick Dievendorff]

I googled "stepper y cable" and found these.  Maybe the other "hits" will be of use as well.

http://www.steppir.com/wp-content/uploads/2011/10/Y-Cable.pdf

http://www.steppir.com/wp-content/uploads/2011/10/Transceiver-Interface-Operation-5-28-09.pdf

Have fun!

73 de Dick, K6KR




-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jean-François Ménard
Sent: Wednesday, December 14, 2016 11:57
To: elecraft at mailman.qth.net
Subject: [Elecraft] SteppIR controller with K3S+P3

Hi everyone!

I am a happy new owner of a brand new K3S and a P3, and everything is working quite well.

Now, I would like to connect my SteppIR SDA-100 antenna controller to the K3S. I would like to be able to not use the computer to control the antenna controller.

Any suggestion from a few hams with similar setup as mine on how to use the SDA-100 without the needs of a computer?

My guess is I should do a Y cable between the connector labeled PC behind the P3 by using only the PIN 2 and 5 then thru the SDA-100 ???

73 de Jeff | VA2SS 

__________________________________________
Jeff | VA2SS
Jean-François Ménard

jean-francois.menard at va2ss.com <mailto:jean-francois.menard at va2ss.com>
www.VA2SS.com <http://www.va2ss.com/>

Message envoyé à partir de mon appareil mobile.
Message sent from my portable device.

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message delivered to dick at elecraft.com