[Elecraft] KX3 utility on RPi

[Niel Skousen]

Duh Mint...

Niel

Sent from my iPhone

> On Dec 13, 2016, at 18:15, Niel Skousen <nskousen at ecsecurityinc.com> wrote:
> 
> I've been using Mike t on a Dell e4200.  I seem to recall is wa the 32bit compatibility lib's.  Elecraft's SW is built ( if I recall) as 32bit apps.  
> 
> Will ping you seperately offline for some questions.  
> 
> Thanks
> 
> Niel
> WA7SSA
> 
> Sent from my iPhone
> 
>> On Dec 13, 2016, at 17:53, James Bennett <w6jhb at me.com> wrote:
>> 
>> I’ve been using my KX3 connected to a Raspberry Pi 3 for quite some time, using CQRlog for logging, FLDIGI for PSK31, and recently, WXJT-X rc3 for JT9 and JT65. I’d like to load the most current firmware into the KX3 so I can get the full 15 watts out. I downloaded and un-tar’d the KX3 Utility from the Elecraft web site. So - now what? If I click on the “kx3util” executable, nothing happens. What is the secret procedure to get this going? I am using the Raspian Jessie (Debian Linux) OS on this RPi.
>> 
>> Thanks, Jim / W6JHB
>> Folsom, CA
>> 
>> “What’s the difference between a carpenter and a woodworker? About 1/8 inch!"
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nskousen at talisman-intl.com