[Elecraft] LP Bridge crashes with K3

[George Kidder]

Sorry, Larry, but that didn't do it.  (Testing takes a long time!)  Ran 
OK with both sliders max left, for about a day.  Then crashed after 2 
hours, reset with full reboot, crashed again after after several more 
hours.  In short, no change.  Did I change the right thing?  ["control 
panel, device manager, ports, communications port (com 1), port 
settings, advanced.  "Use FIFO buffers" was checked, moved both sliders 
from full right to full left]

Or should I have been putzing with the Eltima settings (virtual Com 19 
and com4) which are called up by LP-BRIDGE?  I cannot seem to find any 
buffer size settings for these virtual ports.

I just now unchecked the "use FIFO buffers" box.  Sliders are grayed 
out.  Seems to work, except now NaP3 has lost it's memory for the last 
frequency used.  Will run this way and see what happens.

Thanks

George, W3HBM


On 12/7/2016 10:43 PM, Larry Phipps wrote:
> The largest option that they offer for both xmt and rcv buffers.
>
> Larry
>
>
> On 12/7/2016 7:34 PM, elecraft-request at mailman.qth.net wrote:
>> Subject: Re: [Elecraft] LP Bridge crashes with K3
>> >Date: Sun, 04 Dec 2016 18:43:53 -0500
>> >From: George Kidder<gkidder at ilstu.edu>
>> >Reply-To:gkidder at ilstu.edu
>> >To:elecraft at mailman.qth.net
>> >
>> >
>> >
>> >No I have not, Larry.  What settings do you recommend for starters?
>> >
>> >George
>> >
>> >
>> >On 12/4/2016 11:02 AM, Larry Phipps wrote:
>> >
>>> >>Have you tried adjusting the buffer settings in Device Mgr for your
>>> >>serial port?
>>> >>
>>> >>Larry N8LP
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to gkidder at ilstu.edu