[Elecraft] Adjust ALC in Data A mode, with KX3

[David Douglass]

Hi,

I've just re-acquired a KX3, and have been trying it on JT65.

As per recommendations I have been trying to use Data A mode, but trying to adjust the drive level is a nightmare, and getting the required 4-5 bars of ALC has been near impossible. If I switch to USB mode, I can set the drive levels without issue using the mic gain, and adjusting the sound are levels.

I would have assumed that setting drive levels would be the same in USB mode as it was in Data A mode. Is this not the case or do I having something else going on. 

Apologies as I appreciate the subject of JT65 has been covered extensively in the past, but I can't figure out why I seem to be able to set things up in USB mode easily, but can't in Data A.

Cheers

David, vk2nu

Sent from my iPad