[Elecraft] Fwd: Aw: Re: [K3] IF Out usage with SDRPlay

[tomb18]

Hi I forwarded your message to the group.To use the sdrplay with the k3 you must tune the sdrplay to 8.215 mhz and never change it from there. No matter what band is on the radio, the signals will be correct. However you may need to change an offset frequency depending on the software.73 Tom va2fsq.com 

Sent from my Samsung Galaxy smartphone.
-------- Original message --------From: Harald Fritzsche <dd0vs at gmx.de> Date: 2016-12-01  2:47 AM  (GMT-05:00) To: tomb18 <tomb18 at videotron.ca> Subject: Aw: Re: [Elecraft] [K3] IF Out usage with SDRPlay 

Hello,

 

Content is removed by some system, i sent it twice with content :-(

 

tnx fr info

vy73

Harald

DD0VS

 

 



Hello Readers,

 

i am using an SDRPlay SDR attached to IF out of K3 and was believing, that this device is listen onf IF level.

 

But i assume (after reading some articles) that, when i switch the K3 to 40m and the SDR to 40m, then i see part of the antenna signal passed through the mixer, rigth?

 

Thanks for Help

 

merry X-Mas

vy73

Harald



Gesendet: Donnerstag, 01. Dezember 2016 um 08:02 Uhr

Von: tomb18 <tomb18 at videotron.ca>

An: "Harald Fritzsche" <dd0vs at gmx.de>

Betreff: Re: [Elecraft] [K3] IF Out usage with SDRPlay


Your message is blank

 

 

 


Sent from my Samsung Galaxy smartphone.


 


-------- Original message --------

From: Harald Fritzsche <dd0vs at gmx.de>

Date: 2016-12-01 1:16 AM (GMT-05:00)

To: elecraft at mailman.qth.net

Subject: [Elecraft] [K3] IF Out usage with SDRPlay

 



______________________________________________________________

Elecraft mailing list

Home: http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/mmfaq.htm

Post: mailto:Elecraft at mailman.qth.net



This list hosted by: http://www.qsl.net

Please help support this email list: http://www.qsl.net/donate.html

Message delivered to tomb18 at videotron.ca