[Elecraft] K3/KAT500

[ab2tc]

Hi Don & Alan,

Without the KAT3 present the ATU TUNE button has no effect other than
displaying the "NO ATU" message briefly. This goes for both tap and hold. As
you say, use the TUNE button to generate a medium power (set by "TUN PWR" in
config) carrier. This will cause the KAT500 to recall a stored setting or
tune if necessary if in AUTO mode. It's a little murky to me under what
circumstances it will tune if in MANUAL mode, but it will usually at least
do a recall of  stored setting if it has one.

AB2TC - Knut


Don Wilhelm wrote
> Alan,
> 
> I am going to guess - the difference may be the result on the KAT3 
> present in the K3 or not present.
> 
> My perusal of the K3 manual indicates that the ATU TUNE button refers to 
> the KAT3 - I see no exceptions for the KAT500.  I really don't know what 
> happens if the KAT3 is not present.
> 
> So for that K3, you would use TUNE for tuning the KAT500.  In order for 
> the KAT500 to find a match, set the K3 TUNE PWR menu to 10 watts or more 
> (20 watts is better).
> 
> 73,
> Don W3FPR
> 
> On 8/11/2016 10:27 AM, G4GNX wrote:
>> Probably a few dumb questions but...............
>>
>> I’ve been trying to setup our club’s K3/KAT500 combination and it’s not
>> performing as expected. At present, it’s just the K3 and KAT500, no
>> linear involved.
>>
>> I’ve connected the AUX data cable to the K3 and KAT500 and I have a patch
>> cable between K3 ANT1 and KAT500 XCVR connectors. This is the Aux cable
>> supplied by Elecraft.
>>
>> The K3 CONFIG:KAT3 is set to KAT500Y and the KAT500 switches chosen
>> antenna when the K3 band is changed as expected, so I presume that data
>> is being passed correctly between them.
>>
>> However, when the KAT500 is set to AUTO, I can only initiate a tune cycle
>> by holding the TUNE button on the K3. If I tap the ATU TUNE button on the
>> K3, if the KAT3 is shown in BYPASS then nothing happens. If the KAT3 is
>> shown in AUTO then the KAT3 does the tuning, not the KAT500.
>> Also, pressing the TUNE button on the KAT500 only seems to make the AUTO
>> LED blink, although I’m guessing that it’s to indicate that I need to set
>> the K3 to transmit (hold TUNE)?
>>
>> One of our members who has dealt with a lot of Elecraft equipment says
>> that with the KAT500 correctly connected and CONFIG:KAT3 set to KAT500Y,
>> tapping ATU TUNE should put the KAT500 into a tuning cycle, not the KAT3,
>> which he says is a normal function.
>>
>> Am I totally misunderstanding how the system is supposed to work, being
>> misled, or have I missed a CONFIG or setup step?
>>
> <snip>





--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-KAT500-tp7621498p7621517.html
Sent from the Elecraft mailing list archive at Nabble.com.