[Elecraft] KX3, KXPA100 and KX Utility Software

[Don Wilhelm]

Frank,

I think you will be happier using the soundcard route.
The KX3 Utility will PSK-D, FSK-D or CW.
If you already have the capability to download firmware to the 
KX3/KXPA100 or to save the configuration, etc using KX3 Utility, you are 
all set - just go to the Terminal tab, then tune the KX3 to the station 
of interest (and set the proper data submode - or CW) and it should be 
decoded.
Type in the transmit window and it should be transmitted.

If you want the conventional waterfall display and point to the signal 
and click to tune it, use the soundcard and select DATA A for all but 
RTTY where you will want to use AFSK A.

73,
Don W3FPR

On 8/8/2016 12:04 PM, f12547 at gmail.com wrote:
> Because I can't seem to figure out how to search the list to find an answer
> to my question, I am posting this question.
>
> How does one configure (cable) a KX3, KXPA100 and a computer to use the
> Elecraft KX3 Utility software for data modes?
>
> Or, must I have to go the sound card route and use a different program for
> digital modes?
>
>