[Elecraft] KXBC3 install...

[Walter Underwood]

The KXBC3 is very easy to install. As I remember, the trickiest bit was getting the adhesive shield lined up right before I stuck it on.

Installation instructions are here, starting on page five. You can open up your radio and look at the screws where it will go. I don’t remember them being especially tiny.

http://www.elecraft.com/manual/E740167%20KXBC3%20Installation%20Manual%20Rev%20A.pdf <http://www.elecraft.com/manual/E740167%20KXBC3%20Installation%20Manual%20Rev%20A.pdf>

wunder
K6WRU
Walter Underwood
CM87wj
http://observer.wunderwood.org/ (my blog)

> On Aug 5, 2016, at 2:55 PM, Tom Francis <w1tef at swsports.org> wrote:
> 
> Greetings,
> 
> What I didn't order with the KX3 was the internal battery charger. Now
> that I have the KX2 and know how handy it is to have the internal battery,
> I'm considering getting the KXBC3 for my KX3.
> 
> What I need to know is how hard is it to install?  I have advanced arthritis
> in my fingers and I'm a bit "shaky" on top of that (nerves) so if it involves
> little tiny parts, I'm going to have to look for some help from friends which
> I would rather not do - I'm stubborn that way. :-)
> 
> Thanks for any information.
> 
> Tom, W1TEF
> Lexington County, SC
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wunder at wunderwood.org