[Elecraft] k3s radio kit

[Don Wilhelm]

For those not familiar with screw dimensions, pay attention to the 
information on the right side of page 12 in the assembly manual. Flat 
Head screws are measured from the top of the head to the bottom of the 
threads while Pan Head  (and round head and others) are measured from 
the bottom of the head to the end of the threads.

73,
Don W3FPR

On 8/5/2016 3:16 PM, rboutell wrote:
> "... If you are not accustomed to judging screw lengths accurately, use a
> ruler to measure them. "
>
> I just wanted to throw in my 2 cents:
> Pay very close attention to the screw lengths and sort them out carefully. A
> 4-40x3/16" Pan Head might work when a 4-40x1/4" is called out, but later you
> may need the 3/16" and the 1/4" is tooo long :)
>
> 73, Russ
> W9EL
>
>
>
> --
> View this message in context: http://elecraft.365791.n2.nabble.com/k3s-radio-kit-tp7621215p7621242.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to donwilh at embarqmail.com
>