[Elecraft] K3S Build - What have I forgotten

[richarddw1945 at yahoo.com]

Andrew,
Make sure you have the appropriate mic connector turned on (rear or front).  Set mode to SSB< TAP (not hold) the Menu button, then turn VFO B knob to mic setting, then set the right mic input (or line) with the VFO A knob.  Also, depending on your mic, you might need to turn on the mic bias using the "2" (REV) pad by tapping it on or off.
Dick, K8ZTT
On Sat, Apr 30, 2016 at 5:09 PM, Andrew Hebden <andrew at ahebden.com> wrote:

> Hi,
> I have completed my build following the manual and everything seems to work
> fine until I started to try and set it up for SSB. I can get full output
> using the two tone test but nothing through the microphone. I also tried a
> another microphone plugged in to the rear mic socket. Still nothing.
> Any suggestions?
>
> Andrew
> G8BYB
>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to esteptony at gmail.com
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to richarddw1945 at yahoo.com