[Elecraft] K3s - No transmit

[Don Wilhelm]

Gary,

If K3 Utility does not do the job for you, use the K3 menu directly - 
see page 51 in the manual.

Go into the menu and set all your filters to ON.  Set FLx BW, FLx FRQ, 
FLxGn, FLX ON for each filter.  Then set FLTX to the appropriate filter 
per mode.  For CW and SSB set it to the 2.7 (or 2.8 filter),  For AM, 6 
kHz if available, otherwise the 13kHz, for FM the 13kHz if installed.  
K3 Utility should show you the same thing as recorded in the menu.

Make sure the filters are plugged in the K3 RF board from highest to 
lowest as indicated on the silkscreen.

Has it been working before? or is this a recent problem?  If working 
before, what has changed?

73,
Don W3FPR

On 4/27/2016 9:18 PM, Gary Smith wrote:
> There is:
>
> 2.8K is for CW and SSB
> 6K is for AM and the FM is checked by default.
>
> Installed in the main is:
> FL1 6K - {AM}
> FL2 2.8K - {CW & SSB}
> FL3 1K
> FL4 400 Hz
> FL5 200 Hz
>
> Sub:
> FL1 6K
> FL2 2.7K
> FL3 1K
> FL4 500 Hz
> FL5 250 Hz
>
>
> When running through Config I only see FL4 listed, no other filters
> show up as in FL5, FL3, FL2 & FL1
>
> FL4 Config options read:
>
> FL4 BW  rF .40
> FL4 FREQ  rF 0.00
> FL4 GN  rF 0db
> FL4 ON  rF yes
> FLTX SB FL2
>
>
> 73,
>