[Elecraft] K3s - No transmit

[Kevin Stover]

Open up the utility again and make sure you have specified a transmit 
filter for all modes.

On 4/27/2016 7:51 PM, Gary Smith wrote:
> I just added some filters to the K3s and configured the filters with
> the K3 config. The radio hears perfectly on all the modes and the
> filters are working beautifully. now however, it does not transmit.
> It is not in test mode.
>
> I did nothing else to the radio while I had it open.
>
> Tapping a key, SSB or pressing XMIT and there is zero output.this at
> 1W or 25W.
>
> The red TX LED lights.
>
> It signals the relay in the amp properly.
>
> On the P3 transmit monitor I see .02-.03W PEP registering, no SWR
> reading and the LP-100A shows no sign of a signal.
>
> I restored a known good configuration with no change.
>
> No error messages are showing, no warning message on startup.
>
> 13.6 V on the K3 meter.
>
> trying the ATU, it shows 5W on the display, relays clack, no output
> on the P3 output except that .02-.03W & nothing on the LP100A
>
> I have triple checked to be sure all the coax to the Synths, TXCO &
> Sub are attached properly.
>
> I have made sure all the connections to the sub RX are inserted
> properly.
>
> I must be missing something obvious. Any ideas what I might look at?
>
> Thanks
>
> Gary
> KA1J
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to kevin.stover at mediacombb.net
>


-- 
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus