[Elecraft] Wattmeter for K3s Calibration

[Don Wilhelm]

Clay,

I see nothing in the K3 manual about Tune PWR calibration.
There is the wattmeter calibration for which you need a good 50 ohm 
dummy load and a wattmeter that you can trust.
The other is the TX Gain Calibration which needs only a good 50 ohm 
dummy load.

If those are both done, then your TUNE PWR setting will be accurate.

73,
Don W3FPR

On 4/26/2016 11:15 PM, Clay Autery wrote:
> Not referring to the XMTR Gain cal...  talking about the Tune PWR cals...
>
>