[Elecraft] KX3 2m Install

[Ron D'Eau Claire]

Hi Bruce:

Are talking about C180 near J4? I'll check into it. It won't be the first
time the engineers made a change and didn't realize it impacted the assembly
instructions (I'm 600 miles from Watsonville, but only milliseconds by voice
and e-mail. Still that can be "light years" at times, Hi!) 

I'm not sure what could put the TO-220 screw at an angle. The TO-220 heat
sink simply slips in between the retainer, which is then pulled tightly
against the TO-220 heat sink and the side of the case. That's the critical
part - good mechanical and thermal contact between the TO-220 heat sink and
the side of the case. 

Have you tried loosening both screws and then re-tightening them? What comes
to mind is that in tightening the top screw, the retainer might have turned
slightly, misaligning the bottom screw in the hole. With everything in
place. Loosen both screws a bit, then retighten the bottom (nylon) screw to
hold the retainer, then tighten the top screw and see if things line up
better. 

I'd appreciate hearing if that works either at my address on this message or
ron at elecraft.com. 

73. Ron AC7AC

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Bruce
Nourish
Sent: Monday, April 25, 2016 5:37 PM
To: Elecraft Reflector
Subject: [Elecraft] KX3 2m Install

Hi folks,

Last night I installed and configured a KX3 2m module following the current
instructions on the website (Rev C). My KX3 is a recent factory build.
Everything seems to be working fine; I haven't actually tried it on-air yet
(need to finish my 2m Moxon), but at least I didn't blow my rig up.

I encountered one difference with the instructions: When installing the LO
coax on J4, I could not find any capacitor C120 to avoid. My KX3 simply
doesn't have C120 or R81 on that PCB. Has something changed in recent KX3s?

The only hard part was the final installation, specifically clamping the
heatsink lug properly with retainer TO-220. It seems like the clamping
arrangement unavoidably puts the nylon bottom screw at a weird angle. I
double-checked the orientation of TO-220 and redid these steps over several
times, and couldn't figure out any other way to make it work. Is this right?
If so, a clarification in the instructions would help.

Bruce
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to ron at elecraft.com