[Elecraft] K2/100 and KAT2

[Kevin Stover]

http://wilcoxengineering.com/kpa100-in-ec2/

You've got to have the KIO2, an EC2 enclosure, and the KAT100PNL kit.
KIO2 goes in the QRP K2, KPA100 and KAT100 go in the new EC2 enclosure 
which has the KAT100PNL kit installed.
Assuming you've got the KAT100-1 you can use the serial cable you built. 
K2 end goes to the new KIO2, tuner end goes to either the KPA100 or the 
KAT100, left over connector goes to PC.

On 4/16/2016 10:47 AM, Dauer, Edward wrote:

  Another possibility for a quick conversion to QRPis to move both the 
KAT100 and the KPA100 to an EC-2 enclosure and install the KAT2 in the 
base K2. I have seen references in the archives to the possibility of 
doing that conversion, but they leave a number of questions open. Once 
the KPA100 is installed in the K2, is it possible to move it over to an 
EC-2 with the KAT100? If so, is there a procedure published somewhere?


-- 
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus