[Elecraft] Loading Old Configuration Into New K3S

[Walter Underwood]

The configuration includes all the calibration data that is specific to each radio. If you loaded another radio’s config, you would need to do all the calibration over again.

That seems like a very good reason to me.

wunder
K6WRU
Walter Underwood
CM87wj
http://observer.wunderwood.org/ (my blog)

> On Apr 15, 2016, at 4:59 PM, Nr4c <nr4c at widomaker.com> wrote:
> 
> NO. FOR GOOD REASON. 
> 
> Sent from my iPhone
> ...nr4c. bill
> 
> 
>> On Apr 15, 2016, at 7:12 PM, Merle Bone <merlebone at charter.net> wrote:
>> 
>> I tried to load my current K3 configuration into my new K3S and got an
>> error message saying the serial number did not match. Is there
>> a reasonable way to load an older K3 configuration into a new
>> K3S?
>> Thanks,
>> Merle - W0EWM
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to nr4c at widomaker.com
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wunder at wunderwood.org