[Elecraft] Two radios on the KPA500?

[Ron D'Eau Claire]

If you try to use the "enhanced" cabling setup in the Owner's manual that
uses the accessory cable, the K3 will control which band the KPA500 is on. 

I'd use the basic cabling setup shown on page 11, switching both the RF and
key line cables. 

73, Ron AC7AC

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Harry
Yingst via Elecraft
Sent: Friday, April 15, 2016 10:57 AM
To: Elecraft Reflector
Subject: [Elecraft] Two radios on the KPA500?

What would be an easy way to run two radios (a K3 and a generic radio) with
the KPA500 Putting an manual switch on the input to the KPA 500 is easy
enough, but what aboutthe accessory cable that runs to the K3 and the Key
line from the generic radio?
Thank you

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to ron at elecraft.com