[Elecraft] Stripping toroid leads

[Edward R Cole]

I always figured the enamel should be removed.  I just scrape them 
with a small razor knife which leaves the copper bright and ready for 
tinning.  Melting the enamel with my solder iron results in a messy 
glob on the iron and not a very clean lead.  I don't own a solder pot 
but could see that would work except for contamination of the solder 
if you do many.

I am mostly winding air coils for VHF equipment, so its what is 
normally coating magnet wire.

73, Ed - KL7UW
http://www.kl7uw.com
     "Kits made by KL7UW"
Dubus Mag business:
     dubususa at gmail.com