[Elecraft] Stripping toroid leads

[Mike Dodd]

On 4/6/2016 11:13 AM, Dave Heil wrote:
> ...eight enameled leads off the bench.  He then
> straightened the leads and dipped them all about 3/8" into a solder pot.

Remember Vector's "wiring pencil?" 
<http://www.piclist.com/techref/pcbwires.htm> You used it to wire a 
breadboard with #32 enameled wire. Once you wrapped the wire around a 
pin, you applied a soldering iron and solder, which melted the enamel to 
allow a good solder joint.

I still have mine, and used it just a few weeks ago to wire an Arduino 
breadboard.

-- 
73, Mike N4CF
Louisa County, VA USA
Elecraft KX3 + KXPA100 @ 100W
Elecraft PX3 panadapter
Carolina Windom up 45'
http://n4cf.mdodd.com