[Elecraft] Equipment on top of K3?

[Mike Dodd]

On 4/1/2016 10:22 PM, Jim Brown wrote:
> Yes, that works fine, and it's how mine are mounted. I use Velcro tabs
> to keep the P3 from sliding back -- I use the tilt-bale on the bottom of
> the K3 to place it at a good viewing and operating angle.

Thanks to all who replied here and off-list as well. Here is a photo of 
what I'm working with: <http://n4cf.mdodd.com/rig.html#NewRig> I made a 
mockup of the K3, so I think I'll also make one of the P3.

The green foam block probably is taller than the k3's folding wire foot, 
so I might build a sloping wooden stand that places the front panel an 
inch lower. Hopefully that will leave space on top for the P3 to fit 
into the hutch cavity.

If not, there is space to the right of the hutch -- less convenient, but 
workable.

Thanks again, everyone.

-- 
73, Mike N4CF
Louisa County, VA USA
Elecraft KX3 + KXPA100 @ 100W
Elecraft PX3 panadapter
Carolina Windom up 45'
http://n4cf.mdodd.com