[Elecraft] K2 thermistor board check

[lstavenhagen]

Hi Don,
Ok, thanks for the info. Would a resistance check according to the schematic
be reliable at this point (just finished the varactor diode installation
steps)? I dont know if I want to try to power anything up in the half built
state lol.

I'm pretty confident in the daughter board since I checked it over after
flush cutting it, etc. One of the pins got hot enough to melt the solder on
the daughter board itself while I was soldering it to the RF board (my fault
for holding heat onto the pad at RP3 too long) and it rocked out of place a
bit before I repositioned it. 

It looks ok and I dont know if I dare try to get my soldering iron in there
to try to "touch it up". So I'd just like to do a continuity check on that
pin. And maybe the whole board while I'm at it?

Thanks kind sir,
LS
W5QD




--
View this message in context: http://elecraft.365791.n2.nabble.com/K2-thermistor-board-check-tp7615784p7615790.html
Sent from the Elecraft mailing list archive at Nabble.com.