[Elecraft] ACC2

[frank]

I knew there was something I did not understand about that.

That also explains why I had do an ACC2 = ON to make the KX3 work with the KXPA100.

On Wed, 30 Sep 2015 14:29:21 -0700
Wayne Burdick <n6kr at elecraft.com> wrote:

> Frank,
> 
> ACC2 has two outputs: a keyline for the amp (always on), and a general-purpose programmable output (GPIO). The latter is what's controlled by the ACC2 IO menu entry. You can use this signal for various functions as described in the ACC2 IO menu entry. 
> 
> When the amp is used with our custom KXPA100 interface cable, the ACC2 keyline signal is routed to the amp, and the GPIO signal is broken out to its own connector for your use.
> 
> 73,
> Wayne
> N6KR
> 
> 
> On Sep 30, 2015, at 1:25 PM, frank <frank at k5dkz.com> wrote:
> 
> > 
> > ACC2 = OFF  appears to be a factory default.  Why?
> > 
> > Other rigs do not disable the amp keying line.  Why was it neccessary to do that in the KX3?
> > -- 
> > Frank - K5DKZ
> > KX3 - 7550
> > PX3 - 1143
> > KXPA100 - 1566
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> > 
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > Message delivered to n6kr at elecraft.com
> 


-- 
Frank - K5DKZ
KX3 - 7550
PX3 - 1143
KXPA100 - 1566