[Elecraft] [K3] Test Mode TX and TX Monitor?

[Alan]

On 09/29/2015 04:26 PM, Phil Hystad wrote:

>>>The
>>> bar graph registered an SWR of 3:1 (normally about 1.1:1) in
>>> response to key down while in Test Mode.  Yet, the bar graph acts
>>> normally showing the correct SWR in TX mode (not test).

In test mode there is no power out of the K3.  The SWR calculation gets 
confused when both forward and reflected power are zero.  In the next 
code release I'll add a feature to force the SWR to read 1:1 when 
forward power is close to zero.

Alan N1AL