[Elecraft] K3S Proper Grounding

[Al Gulseth]

Instead of a clip-on ferrite, if you're going to have the box open anyway 
might running the hot and neutral through a small ferrite (core or sleeve), 
or in addition to the bypass caps, possibly correct the problem?

73, Al
 
On Sat September 26 2015 7:22:23 pm Bob McGraw - K4TAX wrote:
> You might just add a 0.05 mf 600V capacitor between the black to ground
> and a 2nd one from white to ground at each light.  Likely the Romex
> comes into the box and the lamp is wire nutted on.  Should be pretty
> easy to figure out how to install a couple of bypass caps.
>
> Before working on this, be sure and kill the breaker to the lamp circuit
> as it will be hot all the time, even with the lamp off.
>
> 73
> Bob, K4TAX
> K3S s/n 10,163
>
> My problem with stray RF isn¹t the TV or other electronic appliances, but
> with the exterior motion sensor lights.  500 Watts on 20 meters turns one
> of the three pairs on (always the same one).  Since they are hard-wired
> into the house, clip-on ferrite would be hard to do.  I can live with it
> if I have to. . . only effect is to scare the wildlife.  But, suggestions,
> anyone?
>
> Ted, KN1CBR
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wb5jnc at centurytel.net