[Elecraft] K3 line question

[Don Wilhelm]

Jorge,

The soundcard output level and the K3 LINE IN level work "hand in hand".
I would increase the soundcard line out level in your computer and 
decrease the K3 LINE setting.
6 bars is too much for data modes - strive for 4 bars with the 5th bar 
flickering.
If you are increasing  the mic gain in order to get VOX to trip, you do 
not have your VOX gain set high enough.

73,
Don W3FPR

On 9/25/2015 1:25 PM, Jorge Diez - CX6VM wrote:
> Hello
>
>   
>
> I think I must setup MIC for LINE no more than 12 for RTTY, right?
>
>   
>
> I cannot TX with this setting, my K3 started transmitting with line = 22
>
>   
>
> Is that a problem? I see 6 full bars in ALC
>
>   
>
> New on RTTY and don´t want to have a bad signal, will try to make some QSO´s
> this weekend
>
>   
>
> 73,
>
> Jorge
>
> CX6VM/CW5W
>
>
>
> ---
> El software de antivirus Avast ha analizado este correo electrónico en busca de virus.
> https://www.avast.com/antivirus
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w3fpr at embarqmail.com
>