[Elecraft] K3 / K3S Station setup question

[ae4pb at carolinaheli.com]

It's been a while and I'm a huge proponent of measure twice cut once. I'm
building a hutch for my operating desk. The desk is 4' wide x 28" deep (2'
4"). I'm right handed and my primary mode will be CW. I have both a Bencher
paddle and a generic straight key. I need about 18" wide for my K3S and
future P3. The K3S is 10"x10"x7.25"(stand extended and air gap above it.
Planning to use a 1 x or 2 x 12 for the shelf and 1x for the vertical
supports. 

Not sure on right to left arrangement with me sitting in the middle. Was
thinking keys, then P3, then radio, then space to the left. 
Allowing 3/4" for the end support, 9 inches for the keys to store, 3/4" for
a vertical support, then 18" or so for the P3, then K3S, the 3/4 for
vertical Support. That brings me 29.25" from the Right edge leaving 18" (if
we subtract 3/4" for the end vertical support) for the Eventual AMP. If I
eventually get the External antenna tuner it will go on top of the shelf or
on top of the amp directly if it will fit.

Does this sound like a proper setup to operate CW with the arm on the
desk..etc.. turn dials with the left hand..etc.. I'll have a laptop/monitors
on top of the shelf and a smallish keyboard/mouse on the desktop.

Just trying to get it all worked out so I don't have to remake this thing
several times.. why re-invent the wheel when someone has already done it
right? 

Thanks in advance.
Jerry Moore
K3S SN# TBA Wednesday