[Elecraft] Palstar AT-AUTO with K3

[Mark E. Musick]

Hi Vic,
I have the AT-AUTO and it works great with my K3 and Alpha 9500. I also have
the RS232 switch that Kessler Engineering sells to switch from direct
monitoring of the K3, where it follows the K3 frequency to listening mode
when running a logging program like N1MM. It will run at 38400. You will
have to go into the menu on the AT-AUTO to change it. The AT-AUTO default is
9600 baud.
The manual is on the Kessler Engineering website.
Last I saw they were going for between $800 and $900.
If you have any other questions, I'll try and answer them.

73,

Mark, WB9CIF

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Vic
Rosenthal 4X6GP/K2VCO
Sent: Tuesday, September 8, 2015 8:25 PM
To: Elecraft Reflector <elecraft at mailman.qth.net>
Subject: [Elecraft] Palstar AT-AUTO with K3

I have an opportunity to get a Palstar automatic tuner, the AT-AUTO. 
This is an older version, NOT the new HF-AUTO.

It has an RS232 interface which the manual says can be used in a listen-only
configuration with transceivers that send frequency data from a CAT port. It
does support the Kenwood protocol.

My question is: has anyone used this tuner with a K3, and if so have they
been successful in having it get frequency information via the
RS232 connection in this way?

--
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to markmusick at sbcglobal.net