[Elecraft] Wire labeling - slightly OT

[Byron Servies]

Hi,

I have had trouble with the Brother P-touch labels delaminating after
a short time, and they don't seem to last outdoors at all. I switched
to the 3M label maker, which I believe is a re-branded Brother but I'm
not sure of the cartridge compatibility:

http://multimedia.3m.com/mws/media/988580O/3m-portable-labeller-refill-cartridges-au.pdf

So far, they are lasting longer than the p-touch labels, and the
shrink wrap versions are nice with the vertical printing capability on
the 3M label maker.  3M/Scotch also make wire ID booklets, but I
haven't used them:

http://multimedia.3m.com/mws/media/592245O/06-wire-id-emd-2009-catalog.pdf

HTH,

73, Byron N6NUL

On Tue, Sep 8, 2015 at 11:27 AM, Ron W3ZV <w3zv at verizon.net> wrote:
> I am bound and determined to clean up the K-line rat's nest behind my radio
> desk. I want to label every wire and cable at both ends. Anyone have a
> suggestion, commercial or homemade, to accomplish this? Reply off the list
> to w3zv at verizon.net. Thanks.
> --
> Ron W3ZV
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to byron at n6nul.org



-- 
- Northern California Contest Club
- CU in the Cal QSO Party 3-4 Oct 2015
- www.cqp.org