[Elecraft] K3 Keyout?

[Don Wilhelm]

Why do you need to look at the schematic.  The K3S specification says it 
will handle +200 volts at 5 Amps, so those are the limits at the box level.
No matter what the device data sheet for a device might indicate, there 
can be other considerations in the K3S design (or other 'boxes') that 
say you should observe the specifications for the entire unit rather 
than trying to re-engineer from the device specifications.

73,
Don W3FPR

On 9/7/2015 7:59 PM, Jim Miller wrote:
> I don't have schematics for my K3S but going by those for the K3. The
> KeyOut line (RCA Jack) is driven by a IRF1630 which appears to be out of
> production. Either than or it is a misprint and is actually a IRF630.
>
> If the latter it appears pretty burly. Can I assume it can drive a pair of
> reed relays without suffering an inductive kick failure?
>
>