[Elecraft] KX3 TX calibration failure on 52 MHz

[Don Wilhelm]

Tuck,

Do you know for sure your dummy load is a good 50 ohm load at 6 meters?  
It is always good to check that with an antenna analyzer.
Try repeating the TX Gain Calibration on 52 MHz manually from the menu.
If it completes both 4 and 6 watts without complaint, you are 'good to go'.

73,
Don W3FPR

On 9/4/2015 11:30 AM, Tuck Watkins wrote:
> The problem is the KX3 TX calibration is failing on 52 MHz at 4.0 W. I
> would appreciate some advice on how to proceed with diagnosis and
> correction.
>
>
>
> I attached a suitable 100W dummy load to the KX3. Then I ran the KX3
> configuration utility. I executed the TX Calibration Gain. It runs fine
> with no errors until it reaches 52 MHz. The relevant lines with the
> failure message on the computer screen are:
>
>      Calibrating 52.000 MHz
>      TxGainStartTune Invalid response to "TQ;"
>      Calibration failed
>
> I then decided to try the TX calibration instructions in the KX3 manual.
> As with the KX3 utility all went well except for the 4.0 W at 52 MHz
> test. When I got to 4.0 W on 52 MHz it appeared that the output was
> stable. That is the 4.0 W was holding steady. When I pressed the button
> to turn off the tuning the message in VFO A displayed was "d=017." The
> message in VFO B was "ERR TXG." I repeated the test at 4.0 W. The
> message in VFO B stayed the same. The message in VFO A changed to
> "d=042." A third attempt produced "d=046" message in VFO A. VFO B had
> the same "ERR TXG" message.
>
> I then ran the test at 6.0 W. There was no error. The error does not
> suggest what to do next. Any advice would be appreciated.
>
> Thanks all,
>
> Tuck, W6TUK
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to w3fpr at embarqmail.com
>