[Elecraft] SSB Transmit Problems:K3

[Jerry Moore]

Have you checked the owner's manual? Gain for the DVR can be set
differently. You didn't indicate which radio you have. But the K3S manual,
Page 30.
While speaking into the mic, adjust MON for
the desired level. (DVR playback level can be
set differently; see CONFIG:TX DVR).

-----Original Message-----
From: Elecraft [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of
pastormg2 at verizon.net
Sent: Friday, September 04, 2015 12:31 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] SSB Transmit Problems:K3

Good Afternoon,
This is Mark Griffin, KB3Z. I just installed the KDVR and used config to
turn it on and it did. But, for some reason when I key my microphone I am
not getting any power output or ALC bars. I have it on transmit normal and
the microphone gain has been turned up and down and no change. When I
depress the XMIT/Tune button it gives me power output. Now, I realize that
is a CW Signal. Also, when I use CW it works just fine. I don't understand
why this is happening. It worked just fine before I installed the KDVR. I
also tried disabling it via config and that didn't do any positive. Any
suggestions, would be very much appreciated. Mark Griffin, KB3Z
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to jermo at carolinaheli.com