[Elecraft] kpa500 doesnt follow k3

[Chortek Bob]

Hi Scott,
I have the same problem and have not been able to solve it....
It worked perfectly for a few days and then it developed the symptoms you described - plus the auto power select stopped working on the K3 (rig no longer goes from high power to low power when the KPA500 is enabled).  I will see what suggestions you get.
I may need to send both back to Elecraft to have them look over the equipment.
73,
Bob/AA6VB
      From: NE9U - Jasper <skjasper at att.net>
 To: "Elecraft at mailman.qth.net" <Elecraft at mailman.qth.net> 
 Sent: Friday, October 30, 2015 10:23 PM
 Subject: [Elecraft] kpa500 doesnt follow k3
   
Just hooked  a new kpa500 to a k3.  

when switching bands on the k3, the kpa500 doesnt follow.  it does follow when i apply power.

the reverse does work....if i switch bands on the kpa500, the k3 follows.

tried 2 different auxillary cables...same result with both.

am i missing some setting i need to change?  

scott  ne9u


Sent from Republic Wireless Cray-1
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to bobchortek at yahoo.com