[Elecraft] kpa500 doesnt follow k3

[NE9U - Jasper]

yes, the k3 recognizes when the kpa500 is turned on.

the cables are e850463.  ( i also have a new kat500....i get same result whether i have it or out of line)

radio setting in kpa500 is set to k3

i also updated all firmware yesterday thinking that might help....no change.

scott




Sent from Republic Wireless Cray-1

> On Oct 31, 2015, at 12:28 AM, Jack Brindle <jackbrindle at me.com> wrote:
> 
> Let’s make sure the K3 and KPA are communicating. When you power on the KPA, does the K3 indicate that something changed? It should display
> the KPA power event on the display. If not:
> * what cable are you using between the K3 and the KPA?
> * Check the RADIO setting in the KPA. It should be set to K3.
> 
> Is there anything else connected to the AUX IO ports on either the K3 or KPA?
> 
> - Jack Brindle, W6FB
> Elecraft Engineering
> 
>> 
>> On Oct 30, 2015, at 10:23 PM, NE9U - Jasper <skjasper at att.net> wrote:
>> 
>> Just hooked  a new kpa500 to a k3.  
>> 
>> when switching bands on the k3, the kpa500 doesnt follow.  it does follow when i apply power.
>> 
>> the reverse does work....if i switch bands on the kpa500, the k3 follows.
>> 
>> tried 2 different auxillary cables...same result with both.
>> 
>> am i missing some setting i need to change?  
>> 
>> scott  ne9u
>> 
>> 
>> Sent from Republic Wireless Cray-1
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> Message delivered to jackbrindle at me.com
>