[Elecraft] K3S Split Rx Ant2/Tx Ant1

[Don Wilhelm]

Jer,

It all depends on how you have your K3S physically configured.

If you do not have the subRX installed, that is not possible - although 
you can connect whatever antenna you now have on ANT2 to the RX ANT 
input and select the RX antenna.

If you do have the sub-receiver, then you can use the ANT2 for receive 
on the subRX by selecting the AUX input.  Take a look at the antenna 
routing Figure 4 on page 45 of the K3S manual.  As indicated, the subRX 
AUX antenna input can be connected to either the KAT3 (solid line) or to 
the BNC AUX RF jack (dotted line). Which one is actually connected to 
your subRX AUX input is a decision that is made at the time you built 
the K3S and added the KRX3.  Factory built K3S are normally connected to 
the BNC jack, but you can add the cable to connect it to the KAT3.

If you connected the AUX input on the sub to the TMP jack on the KAT3, 
then when you select the AUX antenna, the sub will be connected to the 
non-transmit antenna.  In other words, if the main is using ANT1, the 
sub will listen to ANT2.  If you switch the main to ANT2, the sub will 
listen to ANT1.

73,
Don W3FPR


On 10/25/2015 11:51 AM, ae4pb at carolinaheli.com wrote:
>   
>
> Hi,
>
>    I've read the owners manual and Fred Cady's K3 manual. Playing with the
> rig and still can't figure this out.
>
> Desired end result:
>
> When working split I want to receive on Ant2 and transmit on Ant1. I have
> the ATU option installed.
>
>   
>