[Elecraft] Unable to Link V FO's (THANKS)

[Cady, Fred]

Here is how you can set up a programmable function key, say a hold of PF2, to toggle VFO LNK on and off:
Hold CONFIG and tune VFO B to VFO LNK menu.
Hold PF2.  The display will say PF2 SET.
Tap menu and now each hold of PF2 will toggle the link on and off.
There are 10 programmable keys, holding PF1 and PF2, tapping M1 - M4, and holding M1 - M4.  If you use an M1 - M4 keys you can't also use it for CW or SSB messages.
Cheers,
Fred



________________________________________
From: Elecraft <elecraft-bounces at mailman.qth.net> on behalf of William H. Hannon <n8pw at neo.rr.com>
Sent: Wednesday, October 21, 2015 9:45 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Unable to Link V FO's (THANKS)

Gentlemen:


    The only thing faster than change was the fast response from the group.

That's what I get for updating the firmware last spring - after low band
season and not paying attention.

And thanks to Fred - as Patton said about Romel - I read your book (books).

Now to re-read the part about Programmable Function keys....

Thanks to all

73, Bill N8PW






:
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to fcady at montana.edu