[Elecraft] QST Review of KSYN3A synth has erroneous TX phase noise plot

[Walter Underwood]

I wish the transmitted noise was presented more like a proof of performance.

One line for the FCC requirement, then a broad line showing the curves of the three best rigs tested so far.

That would give a clear view of whether this transmitter was just barely good enough or among the best.

wunder
K6WRU
CM87wj
http://observer.wunderwood.org/ (my blog)

> On Oct 20, 2015, at 1:30 PM, Scott Manthe <scott.manthe at gmail.com> wrote:
> 
> Maybe. Or maybe the copy editor is a fan of Flex gear. 😊
> 
> Rick, K2XT is correct. Not to go off the deep end here, but a simple correction doesn't undo the damage to Elecraft's reputation that this "error" appearing in print has caused. QST really should reprint the entire review with an explanation of why it is doing that. Maybe they need to reassess (yet again) the quality control in their editorial process.
> 
> 73,
> Scott N9AA
> 
> On 10/20/15 4:08 PM, Bill wrote:
>> This is what happens when there is less then careful/knowledgeable proof reading.
>> 
>> Bill W2BLC K-Line
>> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to wunder at wunderwood.org