[Elecraft] K3 FS: Pristine and Pampered K3 FS

[David and Dianne on Comcast]

Hi Everyone,

Your chance to own a pristine, pampered K3 with 
many options installed at a fraction of the cost new!

K3 #371 is in as-new cosmetic, mechanical and 
electronic condition. I am the original owner, a 
non-smoker, non-contester, non-dxpeditioner.  It 
has been covered when not used. Without blemish. 
Selling to downsize as I now prefer a simpler rig 
with real band-stacking registers.

-K3/100-K Transceiver (#371)
-(2) KSYN3AUPG Upgrades
-KAT3-K ATU
-KRX3-K Sub-Receiver
-KTCXO3-1 TCXO
-KDVR3-DVR
-(2) KFL3A-6K—6 kHz 8-pole in main RX and Sub-Rx 
for ESSB
-(2) KFL3A-2.8K—2.8 kHz 8-pole replacing stock 2.7 
kHz filters in main and Sub-RX
-(1) KFL3A-2.1K—2.1 kHz 8-pole in main Rx only
-(1) INRAD 700 Hz CW 8-pole in main Rx only
-(2) INRAD 500 Hz CW 8-pole in main Rx and Sub-Rx
-K3DSPUPGD DSP Board Upgrade
-K3DSP LPF installed on DSP Board
-K3IOBUFFKT Mod
-REMIOUPGD Mod
-K3AFMDKT Mod

Does not have the KXV3A board installed but it was 
modified, according to Elecraft directions, to 
provide IF output to a BNC connector on the back, 
mounted on the panel over the bay for the KXV3A or 
B. Enables connection to a P3 that was running 
from this K3 until 2012.

All Elecraft (only) approved hardware mods have 
been installed except the 12 VDC OUT Current Mod. 
(Mod kit will be included. Install yourself, it’s 
easy). Other mods performed: the gold pin 
replacements on the PA and DSP board, the HAGC 
mods, the DSP board upgrade and the LPF installed 
on the new main DSP board.  Firmware: 5.38 MCU / 
DSP 2.86.  Both a Nifty Manual and Fred Casey's K3 
book will be included.

Total price new was approx. $ 4,800.00.  Selling 
Price is $2,795.00 Shipped Ground/Insured via UPS 
to the USA

No trades; I will not “part out”; USPS Money 
Orders preferred; No PayPal; Pix sent to 
interested parties.

Please contact me off list with your interest.

TNX es 73 de N1LQ-Dave -- N1LQ at arrl.net