[Elecraft] Frequency Not Synced for Diversity Receive

[Guy Olinger K2AV]

Hi Lee,

Make sure that CONFIG: VFO LNK is set to OFF.  Then when you have done a
hold on SUB button, see that the second decimal point is blinking.

Mine currently reads one dot eight one seven dot six seven. The dot between
seven and six is blinking indicating diversity mode.

You do not have to link VFO's to enable diversity. Diversity does not use
two linked synthesizers. It runs both RX off of the A syn. B syn is used in
diversity only for transmit if you are doing "SPLIT" TX.

Good Luck and 73

Guy K2AV

On Sat, Oct 10, 2015 at 8:29 PM, KY7M <ars-ky7m at cox.net> wrote:

> I am setting up diversity receive using the AUX input for my receiving
> loop.
> After holding the SUB button to turn on DIVERSITY, the speaker output is
> obviously off between MAIN and SUB by a hundred Hz or more.  I can hear the
> same signal on the other speaker most of the time, but the tone is quite
> different.  I installed a pair of new synthesizer boards several months ago
> and all else seems to be working properly.  Any suggestions?
>
>
>
> Lee, KY7M
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k2av.guy at gmail.com
>