[Elecraft] [KAT500] PC Data to Amp Control?

[Dick Dievendorff]

The KAT500 can read, but not pull down the 4 band change lines. 

Dick, K6KR

Sent from my iPhone

> On Oct 8, 2015, at 21:07, Cliff Frescura <cf at cfcorp.com> wrote:
> 
> Hi,
> 
> 
> 
> If I change bands on the KAT500 via the PC Data port, it appears that the
> new band data is not sent to the Amp Control connector.  Is this expected
> behavior? (hoping no).
> 
> 
> 
> For reference, my setup is:
> 
> 
> 
> Kenwood TS-940
> 
> DXLabs Logging program
> 
> KAT500
> 
> KPA500
> 
> 
> 
> The 940 is connected to the computer and controlled by DXLabs.  DXLabs is
> configured to send commands to the KAT500 (follow the 940).  This all works
> fine.  I'm now trying to have the KPA500 follow the KAT500 via the Amp
> Control connector on the KAT500 (with E850463 cable).
> 
> 
> 
> 73,
> 
> 
> 
> Cliff K3LL
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to dick at elecraft.com