[Elecraft] k3 SO2V

[Arie Kleingeld PA3A]

In your case there's one RX to receive one frequency at the time.
To monitor two freqs /at the same time/, you will need the Sub RX.

Arie PA3A


Op 30-11-2015 om 13:16 schreef simon m0vky via Elecraft:
> hi
>
> recently purchased and built a k3S, without the SUB RX.
> i was under the impression that you could RX on the same band but on 
> VFO A and VFO B.
> ie, to RX the DX QRG and RX the pile up when working split.
> this appears not to be so.
> do i need to buy the SUB RX board to be able to do this or am i not 
> doing something correct?
>
> ps, fb rig.
>