[Elecraft] P3 Showing Transmit Signal

[Alan]

The K3 is supposed to send a command to the P3 to tell it whether it is 
in transmit or receive mode.  Apparently sometimes that isn't happening 
for some reason.  It could be an intermittent RS-232 connection between 
the K3 and the P3 or perhaps some software running on a PC is 
overloading the RS-232 with tons of commands.

Alan N1AL


On 11/24/2015 08:55 AM, Bud Governale wrote:
> I noticed this weekend that occasionally during transmit instead of the
> scan freezing in place it would continue scanning showing only my
> transmit signal with only that signal appearing in the black waterfall.
>
> I don't have the P3TXMON. It never did this before.
>
> I was viewing the external SVGA monitor.
>
> Any idea why?
>
> 73,
>
> Bud W3LL
>
>
>
>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to n1al at sonic.net
>