[Elecraft] K3 KIO3

[Mike Reublin NF4L]

Not the issue. The post was meant for support, not the list. Mea culpa!

73, Mike NF4L


> On Nov 24, 2015, at 7:59 AM, Per-Tore Aasestrand <ptaa at ieee.org> wrote:
> 
> The P3 translates the speed of the K3.
> Both K3 & P3 should be set to the same baudrate for performance reason.
> 
> P-T
> LA7NO
> 
> 
> On 24 November 2015 at 13:54, Mike Reublin NF4L <nf4l at comcast.net <mailto:nf4l at comcast.net>> wrote:
> I'm writing a Windows program for the K3. It connects at 38400 only. In trying to figure out what's wrong, I set my P3 and K3 to 9600 and used the K3 Utility. It will not connect.
> 
> If I set the K3 to 38400 and leave the P3 at 9600, the utility connects, but reports it's connected at 9600.
> 
> Puzzlement is rampant.
> 
> 73, Mike NF4L
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft <http://mailman.qth.net/mailman/listinfo/elecraft>
> Help: http://mailman.qth.net/mmfaq.htm <http://mailman.qth.net/mmfaq.htm>
> Post: mailto:Elecraft at mailman.qth.net <mailto:Elecraft at mailman.qth.net>
> 
> This list hosted by: http://www.qsl.net <http://www.qsl.net/>
> Please help support this email list: http://www.qsl.net/donate.html <http://www.qsl.net/donate.html>
> Message delivered to ptaa at ieee.org <mailto:ptaa at ieee.org>