[Elecraft] [P3] Can I?

[Alan]

Of course in fixed-tune mode the screen always displays the same fixed 
frequency range -- as you tune the K3 VFO, the cursor moves across the 
screen while the displayed frequency range remains the same.

In tracking mode, you can offset VFO A to the left side of the display 
using the CENTER control.  (You have to have enabled the CENTER control 
using the CenterEn menu item.)

Once you do that, the VFO A cursor will remain at the same position on 
the display as you tune the VFO.  If you have the display set up to show 
(let's say) -1 kHz to +9 kHz from the VFO frequency, it will continue to 
do so.

Alan


On 11/18/2015 12:36 PM, Mike Reublin NF4L wrote:
> Span is set at 10. When chasing DX split, is it possible to position
> the VFO A cursor at the left edge of the display and have the right 5
> kHz expanded over the (almost) full screen?
>
> In trying to achieve this, I got it so that when in tracking mode the
> A VFO moves the magenta cursor as well as the A & B markers. The B
> VFO also moves the magenta cursor. The green cursor doesn't move. Is
> this working as intended?
>
> 73, Mike NF4L
>
>
> ______________________________________________________________
> Elecraft mailing list Home:
> http://mailman.qth.net/mailman/listinfo/elecraft Help:
> http://mailman.qth.net/mmfaq.htm Post:
> mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net Please help support this
> email list: http://www.qsl.net/donate.html Message delivered to
> n1al at sonic.net
>