[Elecraft] Feature request: OFS Knob as frequency fast up/dn

[Peter Pauly]

The Rounding YES/NO doesn't seem to have any effect. What should I be
seeing?  2.5Khz is the highest value I can set.

On Mon, Nov 16, 2015 at 8:28 PM, Don Wilhelm <w3fpr at embarqmail.com> wrote:

> Peter,
>
> I assume you are talking about the KX3.
> It is already there - look at the VFO CRS description on the manual (see
> page 40).  Note that this is a per mode setting.  No firmware change is
> necessary.
>
> The K3 (and K3S) has something similar but uses the RIT knob if CONFIG:
> VFO OFS is set to ON and both RIT and XIT are OFF.
>
> I use that regularly on both my K3 and KX3.
>
> 73,
> Don W3FPR
>
>
> On 11/16/2015 8:13 PM, Peter Pauly wrote:
>
>> One of the few things I miss from my Kenwood TS-590S is the Multi/CH knob
>> that lets you change the VFO frequency up or down 5 KHz for each encoder
>> transition. I used this all the time to go quickly to a frequency within a
>> band. It was even usually faster than the manual keypad entry.
>>
>>
>>
>