[Elecraft] Feature request: OFS Knob as frequency fast up/dn

[Don Wilhelm]

Peter,

I assume you are talking about the KX3.
It is already there - look at the VFO CRS description on the manual (see 
page 40).  Note that this is a per mode setting.  No firmware change is 
necessary.

The K3 (and K3S) has something similar but uses the RIT knob if CONFIG: 
VFO OFS is set to ON and both RIT and XIT are OFF.

I use that regularly on both my K3 and KX3.

73,
Don W3FPR

On 11/16/2015 8:13 PM, Peter Pauly wrote:
> One of the few things I miss from my Kenwood TS-590S is the Multi/CH knob
> that lets you change the VFO frequency up or down 5 KHz for each encoder
> transition. I used this all the time to go quickly to a frequency within a
> band. It was even usually faster than the manual keypad entry.
>
>