[Elecraft] KSYN3A and QSK

[Guy Olinger K2AV]

Yes, RIT is off as are some other features for QRQ mode.

With the new syn QRQ mode becomes finally what it was intended for, a
speciality mode for doing 80 WPM full break-in. And the ridiculous less
than one millisecond TX RX TX state change budget, required to hear between
bauds at that speed, mandates a no-frills necessities only lean and mean
state change task list in the programming executed between bauds.

I would think that it's time to drop the confusing old/new QSK distinction
if new Syns are detected. Or keep and call them smooth/sharp or some such,
sharp being I want to hear as much as possible between bauds, smooth being
hear as much as can without clicky or popping sounds.

73, Guy K2AV

On Friday, November 13, 2015, ok1rp <indians at xsmail.com> wrote:

> Yes, it is as Guy said and I agree.
> Normal QSK is improved as reported and tested by several ops and I do not
> worry which QSK is set at 40wpm or so on my K3 with   new KSYN3A.
> I just mentioned to Barry that new QRQ mode is off when RIT is used...;)
>
> 73 - Petr, OK1RP
> -----
> http://ok1rp.blogspot.com
> --
> View this message in context:
> http://elecraft.365791.n2.nabble.com/KSYN3A-and-QSK-tp7610301p7610306.html
> Sent from the Elecraft mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net <javascript:;>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> Message delivered to k2av.guy at gmail.com <javascript:;>
>


-- 
Sent via Gmail Mobile on my iPhone