[Elecraft] K3 FSK RTTY Problems

[Gordon LaPoint]

Ralph,
     I normally use MMTTY, with DXLabs.   That is not the problem, the 
Mark output of the radio is at ~200hz, NOT 2Khz as normal, and can not 
tell if the space is there or not, due to the super low frequency offset 
from the dial frequency.   I'm setup for SO2V operation with Writelog, 
that also has the problem.  I did check for port conflicts and did not 
find any.
     Thanks for the suggestions!

Gordon - N1MGO

On 11/09/2015 08:47 AM, Ralph McClintock wrote:
> Gordon,
>  How are you generating FSK and are you using MMTTY?  It sounds like 
> you are getting PTT but not FSK out of the serial port. There may have 
> been a conflict pop up in your PC for that serial port. I have had the 
> exact problem using MMTTY through MH Digi Keyer & Digi Keyer II.
> Ralph W1ZK
>


-- 
Gordon - N1MGO