[Elecraft] [KX3] Can you switch between two configuration setting?

[Dick Dievendorff]

Gary: 
You might be able to set up a couple of command macros to set the relevant settings, this is exactly the sort of thing they were created to address, 

See KX3 Utility Help for the Command Tester and the K3/KX3 Programming ref on our manual page. 

But Config restore is pretty much all the micro controller's EEPROM, and doesn't have room for several copies, 

73 de Dick, K6KR

Sent from my iPhone

> On May 26, 2015, at 11:55, Gary Hawkins <gary at hawkins-zhu.com> wrote:
> 
> I've started using my KX3 for JT65-HF, in addition to portable SSB SOTA operation.  Obviously the radio is configured differently for both modes (switch on freq, mode, pre-amp setting, power and a number of menu based settings like Mic Bias, Mic Btn, AFX MD). <snip> "Is there a way to set up the KX3 so I can just recall one of two configuration settings from the front panel without use of KX3 utility to quickly switch between the correct settings for these two operating modes?"