[Elecraft] K3, PR6 bypass question

[Mike K2MK]

Hi Emory,

You have to remove pin 11 from the 15 pin connector. You can do it on the K3
side or the KPA500 side. For an explanation search the archive for:

pin 11 problem

It's easy to do. Carefully identify it and grab it with a small needle nose
pliers. Gently wiggle it back and forth and it will break off.

73,
Mike K2MK



ejkkjh wrote
> I can not get the PR6 to bypass?
> I have been using my K3 and PR6 for awhile but I have not tried connecting
> a receive antenna to the PR6 until recently when Wayne said to use the K3
> receive antenna port for 630 meter receive.  I pulled the jumper P2  in
> the PR6.  I have the 15 pin connector that comes with the PR6 connected to
> one side of the Y 15 pin ACC connector from the K3, other side of the Y
> goes to the KPA500, KAT500.  And I have the DIGOUT1 set on for 6 meters
> only, all other bands it is off. If I pull the 3 pin power, ctrl connector
> from the PR6 it goes to bypass and receive ant works fine.  Read through
> the manuals, did not see what I am missing?
> Any help would be appreciated.  Thank you  73
> Emory  WM3M





--
View this message in context: http://elecraft.365791.n2.nabble.com/K3-PR6-bypass-question-tp7602917p7602922.html
Sent from the Elecraft mailing list archive at Nabble.com.