[Elecraft] 6 meter pre amp

[todd ruby]

Dear list members
I must be doing something wrong. I have connected the PR6 pre amp to the KXV3. I run the pwr lead to the accessory output. I leave it permanently on. When I go to 6 meters, the preamp icon comes on but if I push RX ANT to the “ON” position, it is as if I have disconnected the antenna. I also have the 2M module installed whose antenna input is connected to the RX ANT which was installed at Elecraft.

Can someone give me some guidance on the set up for correct operation of the pre amp?

tnx

73

todd
WB2ZAB